This describes the file CTIoscbd.gif

The image shows the layout of the oscillator and output stages
od the CTI PLL boxes from the late 80's.

The image is viewing the oscillator secton from the component
side.  The dark traces are on the bottom of the board.  The 
violet lines show the connections from traces on the component
side.  Components are drawn with schematic symbols.

I couldn't read the values on the two mica caps closest to the
trimmer cap.  They may be custom selected for the crystal 
frequency.  I think this is especially true of the cap near the 
middle of the trimmer.

The passthru in the aluminum divider above the board seems to be
supplying 12.1V to the oscillator.  This is present with the 
external +15V wire attached.

I started to make a schematic diagram of the oscillator.  This is
in the file oscschem.gif.  It is really ugly -- needs to be redrawn.
I have not done anything on the output stages.  There are two C1600
transistors that seem to do this.  These should be 2SC1600 I think.
One 2N2857 is the oscillator transistor. A second 2N2857 seems to be
connected as a diode.  I'm guessing the sample fed back to the 
digital section comes thru the trace at the top of the gif (through
the 1000 cap).

The info I got from CTI talked about adjusting components for the 
loop filter (read the ms doc file).  I don't see anything in the 
analog osc section that looks like these so I assume they are 
components in the digital section.